sgeg
@sgeg
Trusted Member
Joined: Aug 4, 2021
Last seen: Oct 27, 2023
Topics: 5 / Replies: 46
Reply
RE: [Tuto] Use a Toggle switch as Temporary button

@blue111 hi, if the code is good for you you can use the attach one, but you can edit directly edit the original shcustomprotocol.h. Just keep the ...

10 months ago
Reply
RE: [Tuto] Use a Toggle switch as Temporary button

@dzonkins you must disable the button in simhub, no needed it, that why you have issue.. and yes you must solder the switch to the GND and the Pin

1 year ago
Reply
RE: [Tuto] Use a Toggle switch as Temporary button

hello @dzonkins , no problem if i can help... you dont have to configure the button in SimHub , that can be the issue because you have 2 fonctions...

1 year ago
Reply
RE: Can I use the simhub sketch to use along with my own?

@dadima careful when you updade simhub that will delete the custom file so dont forget to save it some where before updade

1 year ago
Reply
RE: how and where add arduino sketch in simhub

hi again, it was to modify the joystick begin line that is not "ON" in displayclient2but you can allow in the customprotocol that is more easy see...

1 year ago
Reply
RE: Can I use the simhub sketch to use along with my own?

Hello, yes that will not change your simhub setting! just respect the usual void setup() { // ... } void loop() { // ... } that are already in ...

1 year ago
Reply
RE: Simulador de viento y otras funciones, ¿Se puede?

the windsimulator will works because you don't control any thing with... it receive only data from simhub but your encoders wont work in game... onl...

2 years ago
Reply
RE: Simulador de viento y otras funciones, ¿Se puede?

hello, it depends what you want to control with your button matrix: -simhub controls like next dash, change LED program or any simhub application ...

2 years ago
Reply
RE: Can I use the simhub sketch to use along with my own?

hello, i dont know how "inject" simhub effect to your sketch but i know how to inject your sketch in Simhub if needed: SHcustomProtocol.h allow you ...

2 years ago
Reply
RE: Belt Tensioner help

actually wotever done a specific belt tensionner, but i dont know if this is compatible with your system... you should try the discord that is very ...

2 years ago
Reply
RE: Belt Tensioner help

hello,is it wotever built you done? did you try to use Arduino IDE instead of Simhubb? the problem with Simhub it will upload all simhub sketch too.

2 years ago
Reply
RE: USB Devices Crashing / disconnecting with Simhub open

hello are you using an USB hub? must be powered if yes

2 years ago
Reply
RE: Can I add buttons to Arduino uno/nano

hello no need the license for led strip management

2 years ago
Reply
RE: Check my wiring diagram for a button box?

@misfitz hi, i am not 100% sure but it should works because the encoders wont be on the same promicro , just need to connect the second promicro GND...

2 years ago
Reply
RE: the Sgeg dashboard

added a button box

2 years ago
Forum
Page 1 / 4