Arduino Tach not working - Projects https://www.simhubdash.com/community-2/projects/arduino-tach-not-working/ All about SimHub! en-US Sun, 16 Aug 2026 13:47:51 +0000 wpForo 60 RE: Arduino Tach not working https://www.simhubdash.com/community-2/projects/arduino-tach-not-working/#post-4982 Mon, 04 Apr 2022 21:25:51 +0000 Ok - fixed it. Suspect there was an issue with the board, might have cracked when it was being cut. All good on a new strip board section. 

]]> Projects MrOdges https://www.simhubdash.com/community-2/projects/arduino-tach-not-working/#post-4982 RE: Arduino Tach not working https://www.simhubdash.com/community-2/projects/arduino-tach-not-working/#post-4978 Mon, 04 Apr 2022 05:13:43 +0000 Hi - did you resolve this? Have the same issue so hoping you found a solution!

Thanks 

]]> Projects MrOdges https://www.simhubdash.com/community-2/projects/arduino-tach-not-working/#post-4978 Arduino Tach not working https://www.simhubdash.com/community-2/projects/arduino-tach-not-working/#post-4399 Sun, 26 Dec 2021 08:41:53 +0000 So I followed the instructions from Amstudio on their Tach project. I was able to get it connected and the board sketch was uploaded. After this I went to calibrate it and nothing happened to the tach. the needle didnt move no matter what RPM setting I chose. Any ideas???

]]> Projects cb34848 https://www.simhubdash.com/community-2/projects/arduino-tach-not-working/#post-4399