Dashboard - using rotary position for permanent display - Simhub General https://www.simhubdash.com/community-2/simhub-support/dashboard-using-rotary-position-for-permanent-display/ All about SimHub! en-US Fri, 14 Aug 2026 03:18:39 +0000 wpForo 60 RE: Dashboard - using rotary position for permanent display https://www.simhubdash.com/community-2/simhub-support/dashboard-using-rotary-position-for-permanent-display/#post-3443 Sat, 02 Oct 2021 23:04:50 +0000 Me interesa el tema como lo llevas? como haces que al girar no sea permanente si no pulsador?

 

saludos.

]]> Simhub General M4nu31 https://www.simhubdash.com/community-2/simhub-support/dashboard-using-rotary-position-for-permanent-display/#post-3443 Dashboard - using rotary position for permanent display https://www.simhubdash.com/community-2/simhub-support/dashboard-using-rotary-position-for-permanent-display/#post-3393 Sat, 25 Sep 2021 10:34:09 +0000 I use a 12-way rotary. Each of the 12 positions is mapped to a windows button (buttons 105 to 116). Changing the rotary position results in a short (not permanent!) button press. Each rotary position is connected to a function (ABS, TC1, TC2, MAP, ...), which then can be increased/decreased by a separate encoder. So with the rotary you choose ABS, with the encoder you then increase/decrease it.

Problem:
I want to permanently display the rotary position on my Dashboard, until it is changed again, so that I have a representation of the current function. So i.e., when I changed to rotary position 1, i want to permanently show "ABS". But because physically turning the knob only causes a short button press for a fraction of a second, i  need something like a "remember last key"-function.

]]> Simhub General MoJay https://www.simhubdash.com/community-2/simhub-support/dashboard-using-rotary-position-for-permanent-display/#post-3393