Wind sim issues (moto shield) - Simhub General https://www.simhubdash.com/community-2/simhub-support/wind-sim-issues-moto-shield/ All about SimHub! en-US Sun, 16 Aug 2026 13:24:06 +0000 wpForo 60 RE: Wind sim issues (moto shield) https://www.simhubdash.com/community-2/simhub-support/wind-sim-issues-moto-shield/#post-8014 Sat, 02 Dec 2023 13:02:35 +0000 Aaaamd fixed.

 

The moto shield was borked. Bough a VNH2SP30 version, hooked it up without changing anything and gets 12v hits every time I press test.

 

This can be closed I guess

]]> Simhub General darkangle https://www.simhubdash.com/community-2/simhub-support/wind-sim-issues-moto-shield/#post-8014 RE: Wind sim issues (moto shield) https://www.simhubdash.com/community-2/simhub-support/wind-sim-issues-moto-shield/#post-7947 Thu, 16 Nov 2023 18:35:46 +0000 I meant to write 25 mV.

 

 

]]> Simhub General darkangle https://www.simhubdash.com/community-2/simhub-support/wind-sim-issues-moto-shield/#post-7947 Wind sim issues (moto shield) https://www.simhubdash.com/community-2/simhub-support/wind-sim-issues-moto-shield/#post-7945 Thu, 16 Nov 2023 14:09:52 +0000 After almost giving up, I thought I'd try here.

 

I cannot for the love of me get the output of my 12v Motoshield above ~25MAh.

 

I've so far checked the following multiple times:

  • The actual upload of the sketch (tried multiple UNO's)
  • The soldering on the MOTO shield (resoldered it even, the pins that is)
  • input on the motoshield is indeed 12V

The only thing that I recently noticed that whilst the example picture on the documentation of SIMHUB spots a dual VNH2SP30 chipset, mine has a VNH3SP30.

 

Could that perhaps be the issue, or is this a know issue of just a bad board and should I rebuy?

 

Kind regards,

 

D.

]]> Simhub General darkangle https://www.simhubdash.com/community-2/simhub-support/wind-sim-issues-moto-shield/#post-7945