Due to increasing spam attacks, forum registrations are currently paused to keep our community safe and spam-free. Come hang out and stay connected with us on the SimHub Discord: https://discord.com/invite/nBBMuX7!
Catch you on Discord — and thanks for understanding!
Catch you on Discord — and thanks for understanding!
Notifications
Clear all
Simhub General
3
Posts
2
Users
0
Reactions
4,183
Views
Topic starter
10/06/2020 12:08 pm
I am trying to put a wind sim program on an arduino Uno clone. The first steps succeed. With setup tool I can get the program on the arduino, but the device is not recognized afterwards. Set to Com4. Connect notifications: Connecting -> Hello -> Model J -> Unrecognized. Can it be a non working clone. It is said to be compatible with Arduino Uno R3. Or does i do something els wrong
Link Arduino Clone:
Link Motorshield:
10/06/2020 12:37 pm
Hi ! If you can upload but can't connect it make me think about a defective motor shield or a short. You can test it easily by simply unplugging the shield. If it connects you will be fixed about it.
Nicolas
Topic starter
10/06/2020 1:13 pm
I have removed the shield and indeed it is now possible to get a connection. Could it be anything else than an incorrect shield?
The shield has a green light. Should this on turn on if there is electricity? First this was off, so i changed the + and Ground. The light on shield went on, but no connection anymore. Now there seems to be no connection at all. Arduino blown up maybe? Program is not responding when compiling 🙁