Due to increasing spam attacks, forum registrations are currently paused to keep our community safe and spam-free. Come hang out and stay connected with us on the SimHub Discord: https://discord.com/invite/nBBMuX7!
Catch you on Discord — and thanks for understanding!
Catch you on Discord — and thanks for understanding!
Notifications
Clear all
Topic starter
26/12/2021 10:41 am
So I followed the instructions from Amstudio on their Tach project. I was able to get it connected and the board sketch was uploaded. After this I went to calibrate it and nothing happened to the tach. the needle didnt move no matter what RPM setting I chose. Any ideas???
04/04/2022 7:13 am
Hi - did you resolve this? Have the same issue so hoping you found a solution!
Thanks
04/04/2022 11:25 pm
Ok - fixed it. Suspect there was an issue with the board, might have cracked when it was being cut. All good on a new strip board section.